This product is no longer available and has been replaced by: CR1000. Some accessories, replacement parts, or services may still be available.
| Services Available | |
|---|---|
| Repair | No |
| Calibration | Yes |
| Free Support | No |
Overview
The CR10 was a predecessor of the CR10X. The CR10X was eventually replaced with the CR1000. The CR10 consisted of a CR10M Measurement and Control Module and a CR10WP Wiring Panel.
Read More
Benefits and Features
- Manufactured from 1987-1996
- Array-based data format
- Repairs still available
Images
Detailed Description
The CR10 had 12 single-ended (six differential) analog input channels, three switched excitation outputs, eight input/output control ports, two pulse counting channels, and a serial I/O port. It provided sensor measurement, timekeeping, data reduction, data/program storage and control functions. Up to 29,908 data points were stored in it's internal memory.
CR10s manufactured after 1 December 1993 (SN>19273) contained an internal jumper that supported use of 2 or 4 kbytes program memory (appropriate PROM also required).
Specifications
| -NOTE- | Note: Additional specifications are listed in the CR10 Specifications Sheet. |
| Analog Input Channels | 12 single-ended (six differential) |
| Switched Excitation Outputs | 3 |
| Input/Output Control Ports | 8 |
| Pulse Count Channels | 2 |
| Serial I/O Port | 1 |
| Memory | Stores up to 29,908 data points in internal memory. |
Compatibility
A typical field-based CR10 system consisted of:
- CR10 with OS10 Operating System
- Alkaline or Rechargeable Power Supply
- Weatherproof Enclosure (CR10s ordered with an environmental enclosure were mounted on the enclosure backplate at the factory)
CR10 peripherals such as the CR10KD and CR10TCR, as well as sensors and data retrieval peripherals, were added to complete the system.
Documents
Frequently Asked Questions
Number of FAQs related to CR10: 1
-
The CPU of the data logger can be removed and mated with a different CR800 wiring panel. This can be done by removing the four corner nuts on the underside of the CR800. Do not loosen the two middle nuts. Be careful not to damage the pins mating the CPU with the wiring panel.
Case Studies
In an era when water is becoming a precious resource, the Emery Water Conservancy District......read more
More than 50 CR10-based monitoring systems were used for structural monitoring during the construction of......read more
Dunhuang (population 100,000) is on the southwestern edge of the Gobi Desert and is situated......read more
The Problem--> Our customer required a data acquisition and control system to monitor a slowly moving......read more
The Poulsbo Marine Science Center is a non-profit educational facility located on Liberty Bay on......read more
Following an inspection a decade ago, the Welsh Office was advised to reduce the allowable......read more
The Space Shuttle Endeavor carried the CR10 and CR9000 data loggers into orbit as part......read more
In a country as large as Argentina, monitoring growing conditions in different agricultural regions is......read more
Privacy Policy Update
We've updated our privacy policy. Learn More