Resistive Bridge Adapters Adapters to help adjust resistive bridge measurements

Conversion Devices and Adapters / Resistive Bridge Adapters

About Resistive Bridge Adapters

Resistive bridge adapters provide the completion resistors necessary for half-bridge measurements, help measure platinum resistive thermometers (PRTs), and are used with strain gages or other sensors that act as a single variable resistor.

Product Line

4WFBS120 120 Ohm, 4-Wire Full-Bridge Terminal Input Module

The 4WFBS120 is a 4-wire, full-bridge module that provides completion resistors for a strain gage or other sensor that acts as a single variable resistor. This module should be used to measure sensors...read more

4WFBS350 350 Ohm, 4-Wire, Full-Bridge Terminal Input Module

The 4WFBS350 is a 4-wire, full-bridge module that provides completion resistors for a strain gage or other sensor that acts as a single variable resistor. This module should be used to measure sensors...read more

4WPB100 100 Ohm, 4-Wire PRT Bridge Terminal Input Module

The 4WPB100 provides completion resistors that allow our dataloggers to measure a 100 ohm platinum resistive thermometer (PRT).read more

3WHB10K 10 kohm, 3-Wire Half-Bridge Terminal Input Module

The 3WHB10K provides the completion resistor required for a 3-wire half-bridge measurement. It is typically used with 100 Ω and 1000 Ω platinum resistive thermometers (PRTs).read more

4WHB10K 10 kohm, 4-Wire Half-Bridge Terminal Input Module

The 4WHB10K provides the completion resistor required for 4-wire half-bridge measurements. This module should be used with sensors that have a 10 kΩ resistance.read more

4WFBS1K 1 kohm, 4-Wire, Full-Bridge Terminal Input Module

The 4WFBS1K is a 4-wire, full-bridge module that provides completion resistors for a strain gage or other sensor that acts as a single variable resistor. This module should be used to measure sensor...read more

4WPB1K 1 kohm, 4-Wire PRT Bridge Terminal Input Module

The 4WPB1K provides completion resistors that allow our dataloggers to measure a 1000 ohm platinum resistive thermometer (PRT).read more

Other Considerations

4WPB500 500-Ohm, Four-Wire PRT Bridge Terminal Input Module

The 4WPB500 provides completion resistors to enable your Campbell Scientific data logger to measure 500-ohm platinum resistive thermometers (PRT) using the half-bridge four-wire measurement method.read more