FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1647 total: showing 661-680)

Can a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used to measure wind flow angle, horizontal angle, and wind speed for the purpose of power curve testing?
If the polymer coating at the ends of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH transducers starts coming off, is that a problem?
What is the absolute accuracy of the speed of sound measurement in the CSAT3/3A/3AH?
Are there any mounting options for the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH that lend themselves to frequent repositioning?
If the temperature drops below -30°C, is that a problem for a CSAT3A or CSAT3B?
Is the CSAT3/3A/3AH only compatible with Campbell Scientific data loggers?
Is the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer measurement limited by precipitation?
Can the bubble level on the CSAT3/3A/3H be replaced?
Can the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used in low-speed conditions, such as less than 5 cm/s? If so, what are the resolution and accuracy at these low speeds?
What are the mounting options for the CSAT3?
Is the offset relatively constant for a single CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
How often does a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer need to be recalibrated?
Is there a way to determine the time at which the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH started reporting data with sub-second precision?
How sensitive are the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH velocity measurements to sea spray in periods of high wind speed?
Does the head of the CSAT3 need to be matched with its electronic box?
Can the CSAT3B or CSAT3BH measurement frequency be changed? If so, what frequencies are supported by these sensors?
How easy is it to replace a defective component, such as a modem, from inside a prewired enclosure?
What is needed to connect a modem to a data logger?
What if I don’t have a Campbell data logger for use with the CS725?
Can the CS725 output in SDI-12 format?

Previous Next