FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1653 total: showing 1221-1240)

How does the CHP1-L work?
What type of sensor is the CHP1-L, and what does it measure?
Can leads for the CMP6-L, CMP11-L, or CMP21-L be ordered in a length of 300 ft? If so, is this a single, continuous cable, or are there two different cables that are joined together?
Do the CMP6-L, CMP11-L, and CMP21-L require a power supply?
To create a network of accurate solar irradiance measurements, do all of the stations need a Class A (secondary standard) pyranometer?
Are the CMP6-L, CMP11-L, and CMP21-L similar in accuracy and measurements?
How can measurements be made using a 107, 108, or 109 temperature sensor/probe with a measurement device other than a Campbell Scientific data logger?
For the 107, 108, and 109 temperature sensors/probes, where within the white cylinder is the thermistor actually located?
Should the dome of the LP02-L be cleaned regularly?
If a LP02-L is reporting 0 W/m², NANs, or unrealistic values, should it be recalibrated?
Does the LP02-L need to be calibrated?
What instruction should be used in CRBasic for the LP02-L?
What type of signal does the LP02-L produce?
What does the LP02-L measure and in what quantities?
How can an SDM-SIO4 and a CR1000, CR3000, or CR800-series data logger be used to send a string from the SDM port out?
Is an SDM-SIO4 necessary to connect a CR1000, CR3000, or CR800-series data logger with a serial sensor?
Why does the graph in LoggerLink not display any historical data?
Can data be collected from a data logger using a USB cable with LoggerLink on an Android or iOS device?
What equipment is needed to link data loggers to a LoggerLink application?
Does LoggerLink require the use of static IP addresses to communicate with a modem?

Previous Next